Page 1 of 1
my z is slightly off what to adjust here
Posted: Sun Apr 14, 2013 1:24 pm
by mhackney
Cambo3D, sorry - I was moving your topic from the "what are you printing" topic to this troubleshooting topic where it belongs. Unfortunately, it got irretrievably deleted - that was not the intent, I simply wanted to move it to the correct area.
Please repost.
Re: my z is slightly off what to adjust here
Posted: Sun Apr 14, 2013 1:27 pm
by cambo3d
Re: my z is slightly off what to adjust here
Posted: Sun Apr 14, 2013 1:31 pm
by mhackney
Yeah, sorry about that.
Re: my z is slightly off what to adjust here
Posted: Sun Apr 14, 2013 1:32 pm
by mhackney
Is it possible that one end lifted from the build surface during the print? Hard to tell from the photo and I forgot the details of your original post's description
Re: my z is slightly off what to adjust here
Posted: Sun Apr 14, 2013 1:44 pm
by cambo3d
mhackney wrote:Is it possible that one end lifted from the build surface during the print? Hard to tell from the photo and I forgot the details of your original post's description
it does look like the left side lifted but that was caused by me in the post process of cleaning up the skirt grid left behind. I started overdoing it by cutting away to much. It seemed the skirt stuck to well to the part.