Page 1 of 1
herringbone gear
Posted: Tue Apr 16, 2013 12:58 am
by cambo3d
gregs wade herringbone gear, using kisslicer, .25layer height, not bad lookin
Re: herringbone gear
Posted: Tue Apr 16, 2013 2:03 am
by ApacheXMD
Hey that's looking great! Your printer is getting really dialed in now. What speeds are you printing with?
Re: herringbone gear
Posted: Tue Apr 16, 2013 2:05 am
by cambo3d
I think I was using 30mm per sec, this took 2.5 to 3 hours to print, but quality is what i'm aiming for. i'm still having some hiccups in my z.
Re: herringbone gear
Posted: Thu Apr 18, 2013 2:23 am
by untitled86
What's that white stuff in the joints of the support for the print head assembly?
Re: herringbone gear
Posted: Thu Apr 18, 2013 2:25 am
by cambo3d
untitled86 wrote:What's that white stuff in the joints of the support for the print head assembly?
lube, to keep the joints moving without friction