OEGInc's Rostock MAX Mini-Build
Posted: Tue Apr 23, 2013 3:25 am
Just thought I would share a couple of my build photos, I have more somewhere that I'll upload at some point when I find them.
Here is how I soldered the wires to my heated bed, I think it's much better this way than in the current assembly manual where they go out and then loop around to go back under the bed.
Here is how I mounted my electronics. I realized after I did it, that it was "wrong" (or different) than what most of you did, but it seemed obvious to me this was how it was "supposed" to be done (or so I thought 
with the exception of the missing spacers, nuts, and bolts. LOL!
And here is how it looks from the front (ignore the fingerprints!)
And here is one of my first prints (actually, I think it's technically my 4th print or so, still needs some calibration)
Here is how I soldered the wires to my heated bed, I think it's much better this way than in the current assembly manual where they go out and then loop around to go back under the bed.
- Wiring to the heated bed.
- 20130327_142542.jpg (11.7 KiB) Viewed 1890 times
with the exception of the missing spacers, nuts, and bolts. LOL!
- Back view of electronics mounted.
- 20130327_171655.jpg (15.09 KiB) Viewed 1890 times
- Side view of the electronics mounted.
- 20130327_171706.jpg (10.58 KiB) Viewed 1890 times
- Front view of the electronics mounted.
- 20130327_171717.jpg (9.47 KiB) Viewed 1890 times
- Printed Lion.
- 20130420_052643.jpg (7.49 KiB) Viewed 1890 times