New From CT

[LorenOlepi]

The good:
I got the Rostock Max and getting close to the end of the build (I think)

The bad:
I just found the forum...go figure!

The ugly:
I'm an aerospace manufacturing engineer and can kick some serious butt in NX cad


Disclaimer:
This will be my first 3D printer so I apologize in advanced for all of the stupid questions I'm bound to ask in the near future

[foshon]

The good:
I got the Rostock Max and getting close to the end of the build (I think)

The bad:
I just found the forum...go figure!

The ugly:
I'm an aerospace manufacturing engineer and can kick some serious butt in NX cad


Disclaimer:
This will be my first 3D printer so I apologize in advanced for all of the stupid questions I'm bound to ask in the near future

Welcome!!

[Durandal]

Welcome, I'm almost done with my build, and I too am rather handy with NX. What version are you running?

[LorenOlepi]

Welcome, I'm almost done with my build, and I too am rather handy with NX. What version are you running?

In Production were running 7.5... upgrading to 8.5 in the near future

[noddynomolos]

Silly Question CT as in Cape Town or CT as in Connecticut (perhaps Carbon Terrestrial ).
Welcome, Look forward to hearing your ideas and sharing information.
I know you have just got your machine together but check out what Brendin (Xnaron) and Warrner Berry have been up to with replacing the arms, universal joints and end effector http://forum.seemecnc.com/viewtopic.php?f=54&t=1704
Brendin has gone on to modify his hotend to a heavly 'moded' j-end and replaced the extruder with a much simpler unit.
Yours,
Don S

[LorenOlepi]

Srry for the late reply as I didn't realize at first to check the notify me at the bottom... CT as Connecticut
Xnaron's arms have def got my attention and plan on doing them real soon! Hope they can hold two hot ends!