Printable EZStruder Top Mount
Posted: Wed Jun 05, 2013 4:31 pm
I created an alternative top mount for the EZStruder. This one has you laying the spool on it's side instead of sitting vertical.
After designing this, I now understand why the other two EZStruder mounts are at an angle when they hang from the top plate. The bowden tube and mounting holes really limit where you can put things and to get a good path from the top of the plate to the bottom, that lets you mount multiple extruders, it needs to be at an angle.
http://www.thingiverse.com/thing:99151
After designing this, I now understand why the other two EZStruder mounts are at an angle when they hang from the top plate. The bowden tube and mounting holes really limit where you can put things and to get a good path from the top of the plate to the bottom, that lets you mount multiple extruders, it needs to be at an angle.