Page 1 of 1
bed now reads 180 / 0
Posted: Wed Jun 12, 2013 3:58 am
by bplemmons
I had some excess solder on my onyx that wasn't allowing the glass to lay flat, I used a solder wick on the thermister solder point to remover the excess, now I have this problem.. Did I fry the thermistor?
Re: bed now reads 180 / 0
Posted: Wed Jun 12, 2013 8:47 am
by geneb
I hate to ask this, but how on earth did you get so much solder in there that it wicked through the vias and came out the other side of the board?
g.
Re: bed now reads 180 / 0
Posted: Sun Jun 16, 2013 11:29 pm
by bplemmons
found the issue, plastic connector on bed thermister was bad
Re: bed now reads 180 / 0
Posted: Mon Jun 17, 2013 7:51 am
by Eaglezsoar
I'm happy for you that it was something simple.
You must have a friend upstairs.