Welcome to the SeeMeCNC Community

What our beloved machine currently needs and is lacking is a decent, elegant dual Jhead effector design.

This would open dual extrusions to more with a proven reliable hotend/hotend mount system.

There is currently no option available in the dual jhead delta area that is lightweight, effective and easily printable.

Anyone......?

Flateric wrote:What our beloved machine currently needs and is lacking is a decent, elegant dual Jhead effector design.

This would open dual extrusions to more with a proven reliable hotend/hotend mount system.

There is currently no option available in the dual jhead delta area that is lightweight, effective and easily printable.

Anyone......?

There is (kinda) http://www.thingiverse.com/thing:38226. The only real issue with it is they sit to far apart and it requires either increasing the hole size of the original effector or printing on specific for the application. Or wait a bit because a little birdie told me Cambo3d is working on something, just a hunch.