Page 1 of 1
Print with sand at $160 a ton
Posted: Fri Jul 26, 2013 10:10 pm
by jmick
Re: Print with sand at $160 a ton
Posted: Sat Jul 27, 2013 12:20 am
by JohnStack
Lawn donkeys!
Re: Print with sand at $160 a ton
Posted: Sat Jul 27, 2013 12:41 am
by kbob
Hey, don't mock the lawn donkey. That particular donkey has
its own Wikipedia page.
Re: Print with sand at $160 a ton
Posted: Sun Jul 28, 2013 2:42 am
by cambo3d
That's interesting but printing with sand brings its own hazards.
sand has silicate in it, when the dust is fine enough it can get into your lungs and cause problems. I'd be more concerned about this than abs or pla.
Re: Print with sand at $160 a ton
Posted: Sun Jul 28, 2013 11:54 am
by JohnStack
I'm dead meat then. I was on the beach for a couple of miles each day.
Re: Print with sand at $160 a ton
Posted: Sun Jul 28, 2013 11:09 pm
by tom10122
theres a solar powered sand printer around teh interwebz
Re: Print with sand at $160 a ton
Posted: Sun Aug 11, 2013 6:18 pm
by barry99705
tom10122 wrote:theres a solar powered sand printer around teh interwebz
http://www.markuskayser.com/work/solarsinter/