Page 1 of 1
Printing a Stratum Vase - LIVE
Posted: Wed Aug 07, 2013 8:17 pm
by Jimustanguitar
Re: Printing a Stratum Vase
Posted: Wed Aug 07, 2013 8:39 pm
by Jimustanguitar
Technical difficulties... Resetting for take 3
1st, The Video made it look like my part was detached from the bed, so I cancelled the job. Upon further inspection, I think it was a reflection/illusion/beer. I'll try again shortly.
2nd, I've jammed my extruder
The filament skipped off the spool and stripped a section. Then when it caught again, it started packing itself into the gears... Let's try this again.
Re: Printing a Stratum Vase - LIVE
Posted: Thu Aug 08, 2013 1:00 am
by Jimustanguitar
[img]
http://i.imgur.com/iEoYcqa.jpg[/img]
[img]
http://i.imgur.com/myxWAHo.jpg[/img]
4 hours later, there's a tiny vase! It came out a little grainy because I was pushing the speed a bit more than I should without a fan, but overall I'm pretty happy. After I add a layer fan, it would be very interesting to try this print again.
Re: Printing a Stratum Vase - LIVE
Posted: Thu Aug 08, 2013 8:20 am
by Batteau62
Very nice Jim!
I caught a little bit of "try 1 & try 2" last night. Just wondering what "beer" variable you used? Lager? Ale? or possibly a nice dopplebock? What temperature? Ambient? Ice cold?
Cheers!
Re: Printing a Stratum Vase - LIVE
Posted: Thu Aug 08, 2013 12:12 pm
by Jimustanguitar
A little 3 Floyds and a little Bell's
Usually Belgian, red's, and IPA's.