The FABtotum anybody seen this yet?
Posted: Tue Aug 27, 2013 12:01 pm
Also, if it goes down for repair, you are out 3 or 4 processes instead of one. 
It would be cheaper for an "occasional" maker but is there such a thing? 
Welcome to the SeeMeCNC Community
Have a look around and join today!
https://download.seemecnc.com/
The FABtotum anybody seen this yet?
Page 1 of 1
Re: The FABtotum anybody seen this yet?
Posted: Tue Aug 27, 2013 12:27 pm
Yes, I noticed a couple of these on 3ders.org. Here's another one: http://www.3ders.org/articles/20130821- ... axing.html I'm not sure how I feel about "all in one" machines? I would get frustrated if I needed to mill something while it was printing something. Also, if it goes down for repair, you are out 3 or 4 processes instead of one. It would be cheaper for an "occasional" maker but is there such a thing?
Also, if it goes down for repair, you are out 3 or 4 processes instead of one. It would be cheaper for an "occasional" maker but is there such a thing? Re: The FABtotum anybody seen this yet?
Posted: Tue Aug 27, 2013 1:43 pm
If I was to design an All in one machine, it'd look like like an octopus, all the hardware in the center, with multi-axis arms flailing everywhere so it could 3d print,mill,cnc,high-five, etc.