Welcome to the SeeMeCNC Community

I printed this pumkin. and while it has some layering flaws, it came out ok. Im thinking its partly the filament. but it couldn't print the upp teeth all the way. Any .10 cents?

[img]http://i1326.photobucket.com/albums/u65 ... 2b8636.jpg[/img]
[img]http://i1326.photobucket.com/albums/u65 ... adc5a2.jpg[/img] [img]http://i1326.photobucket.com/albums/u65 ... 947559.jpg[/img]


On the other hand My first T-glase and glass bed came out nice. Hole looks round, just needing to work in the plug...

[img]http://i1326.photobucket.com/albums/u65 ... 2b3a60.jpg[/img]

You'd have to print it with support material to get the teeth on the upper jaw. To clean up the blobbing around the eyes, you'll need to adjust your retract settings. KISSlicer is good at this. We have a subforum for it here, and if you go there you can download a file with the right settings.

Thanks. Although I have tried KISSlicer, but my prints have come out worse than slic3rs when I load the gcode. I might have to tweak the setting some more.

Have you tried these settings? They worked well for me, better than what I was able to get out of Slic3r. http://forum.seemecnc.com/viewtopic.php?f=15&t=1452