Demo Print
Posted: Wed Feb 26, 2014 11:50 pm
I was asked at work to do a demo for the upcoming Tech Show and Tell day for my local GE site. After poking around a bit internally I found this:
[img]http://i243.photobucket.com/albums/ff27 ... 5e851e.jpg[/img]
I'll use this as my demo print because it's quick and pretty fool-proof, though I will do it in something other than black, probably blue.
I work at a site that does mostly software, so I am apparently the highlight of our site's event
. My hope is the various site events will get published around the internal web sites and the MAX will get some exposure. Outside of the high-end Stratasys and other stuff they use, most of the other machines I have read about are either Makerbots or Cubes. I have to think the build volume on the MAX would be attractive for some of the users. Anyway, I'm looking forward to the day and it should be a lot of fun!
Dave
[img]http://i243.photobucket.com/albums/ff27 ... 5e851e.jpg[/img]
I'll use this as my demo print because it's quick and pretty fool-proof, though I will do it in something other than black, probably blue.
I work at a site that does mostly software, so I am apparently the highlight of our site's event
. My hope is the various site events will get published around the internal web sites and the MAX will get some exposure. Outside of the high-end Stratasys and other stuff they use, most of the other machines I have read about are either Makerbots or Cubes. I have to think the build volume on the MAX would be attractive for some of the users. Anyway, I'm looking forward to the day and it should be a lot of fun!Dave