Welcome to the SeeMeCNC Community

Does anyone have some gcode for moving the device through it's limits to show it off?

IE. Friend shows up and says "What's that do?" and you hit Script X and it goes all crazy for a minute then homes again.

I want to use it as much for printing as for getting attention during events.

Thanks!

Found this code on Youtube…….

https://www.youtube.com/watch?v=KEH7Ji4a3Ss

In the attached file I have removed the first line of his code which was there to set the steps/mm to 40. That is incorrect for our machine and I bet his as well since he had the feedrate set at F12000.
I also reduced that because I could not bare to watch the MAX run like that, F12000 is WAY TOO fast.

Here is the modified gcode that I have been running on my MAX for over 20 minutes now. It just imitates the motion of a spiral and then repeats.

Enjoy….