Welcome to the SeeMeCNC Community

I have a stock effector, E3Dv5 w/ fan, Tricklaser arms but would like a PLA fan. I haven't seen much in Thingiverse I like. Anything have anything simple but highly directed? I'd like to see what print speeds I can get to with one.

Please no elephant trunk thingies! Simple, effective, unobtrusive would be nice!

BTW, I've been meaning to say: I love my Rostock. It's taken a while but I'm getting fantastic prints from it. Short of a jammed head last week (config error), it's rockin'.

Thanks in advance!

How do you have the hot end set up? Is it hanging below the effector? On top? Really depends on how it's mounted to see if one fan with work or the other.

LOL, thanks. Forgot to mention that! It's above!!!