Broken glass plate

A pre-assembled Delta Printer that can print a 6" cube 8" tall!
Post Reply
int2str
Printmaster!
Posts: 193
Joined: Tue Nov 19, 2013 8:38 pm

Broken glass plate

Post by int2str »

I've been using Elmers glue exclusively from day 1 with my ORION. It's been working great for many hours and has never given me problems...
Well, yesterday it happened - the glas plate broke.

After printing a part and letting it cool on the plate, I gently pried the part off (using a plastic scraper) and part of the glass plate stayed attached to the part.... :(

Didn't think this would happen with Elmers only - alas, it did.
Top
User avatar
Eaglezsoar
ULTIMATE 3D JEDI
Posts: 7159
Joined: Sun Apr 01, 2012 5:26 pm

Re: Broken glass plate

Post by Eaglezsoar »

int2str wrote:I've been using Elmers glue exclusively from day 1 with my ORION. It's been working great for many hours and has never given me problems...
Well, yesterday it happened - the glas plate broke.

After printing a part and letting it cool on the plate, I gently pried the part off (using a plastic scraper) and part of the glass plate stayed attached to the part.... :(

Didn't think this would happen with Elmers only - alas, it did.
Sorry to hear that and it is hard to believe it happened with Elmers glue.
Very unusual but it is what it is. I've been lucky so far with my hair spray but my day will come.
Again, I am sorry that this happened to you and I know the sickening feeling in the pit of your stomach when something like this happens.
Better luck in the future.
Top
User avatar
Jimustanguitar
ULTIMATE 3D JEDI
Posts: 2608
Joined: Sun Mar 31, 2013 1:35 am
Location: Notre Dame area
Contact:
Contact Jimustanguitar

Re: Broken glass plate

Post by Jimustanguitar »

Did you break a cheap piece of window glass, or was this a piece of boro glass?
Top
User avatar
Glacian22
Printmaster!
Posts: 330
Joined: Thu Apr 04, 2013 6:07 am
Location: Seattle

Re: Broken glass plate

Post by Glacian22 »

Can I ask what material you were printing with? I remember seeing someone break their borosilicate by printing a very large nylon part...
Top
User avatar
Nylocke
ULTIMATE 3D JEDI
Posts: 1418
Joined: Sun Jun 23, 2013 1:43 pm
Location: Iowa

Re: Broken glass plate

Post by Nylocke »

That... May have been me.....
Top
int2str
Printmaster!
Posts: 193
Joined: Tue Nov 19, 2013 8:38 pm

Re: Broken glass plate

Post by int2str »

Jimustanguitar wrote:Did you break a cheap piece of window glass, or was this a piece of boro glass?
Whatever comes with the ORION.
Glacian22 wrote:Can I ask what material you were printing with?
ABS. I've only ever printed ABS on this machine.
Top
TFMike
Printmaster!
Posts: 306
Joined: Fri Nov 15, 2013 9:11 pm

Re: Broken glass plate

Post by TFMike »

When you cleaned the plate before, what did you use? I found that after numerous prints the glass just goes, I was thinking about sourcing a 1/4" or 3/8" tempered glass piece from Binswanger and seeing how it would hold up. My personal feeling is that the Boro glass that comes with the Orion is a bit too thin.
Top
Post Reply

Return to “ORION”