Built Dreadnought and result of the Gyroid Vase
Posted: Tue Apr 17, 2012 3:47 am
Finished the broadcast of printing the Gyroid Vase, here is the result... no cleaning done
[img]http://www.guanu.net/seemecnc/gyroidvase.jpg[/img]
Also finished printing the rest of the pieces required to assemble the Dreadnought (as a request of a buddy who wanted it)
Should have reprinted the center section for better resolution on that, but in person it looks fine.
[img]http://www.guanu.net/seemecnc/dreadnought.jpg[/img]
Any feedback welcome!
Guanu
[img]http://www.guanu.net/seemecnc/gyroidvase.jpg[/img]
Also finished printing the rest of the pieces required to assemble the Dreadnought (as a request of a buddy who wanted it)
Should have reprinted the center section for better resolution on that, but in person it looks fine.
[img]http://www.guanu.net/seemecnc/dreadnought.jpg[/img]
Any feedback welcome!
Guanu
