Welcome to the SeeMeCNC Community

Hello,
I just purchased the Orion and I followed the manual all the way up to homing it out. Began the homing process and it moves all the way to the top then head jumps to the right, and starts jumping. It seems to me that the filament tube is not long enough to let it home it self out. Have know clue what to do to get this to home out. Any help would be greatly appreciated at this moment. New at this and don't know much about it yet.

I don't know if I'm reading it right... are you homing the towers but one continues to try and go up, 'jumping' to one side? If so, I would wonder if one of your limit switches is damaged and it keeps trying to raise that axis' cheapskate. The 'jumping' might be the belt skipping.

K my fault I finally got it homed out ..........and have printed two objects off that was on the card. Will need a lot of help figuring things out on down loading objects to print and to transfer onto a card for I can print it. I am very computer dumb when it comes to these things....sorry.

Just read through the manual. It should get you going on the process. If you still have troubles, just ask away on the forums.