Page 1 of 1
Ninjaflex dampers?
Posted: Fri May 02, 2014 1:43 am
by McSlappy
Would it be possible to print a thin (2mm thick) plate from Ninjaflex which sits between the Nema 17 stepper motors and the frame? Would this dampen the vibrations at all? Any ninjaflex users able to test?
Re: Ninjaflex dampers?
Posted: Fri May 02, 2014 2:18 am
by bubbasnow
McSlappy wrote:Would it be possible to print a thin (2mm thick) plate from Ninjaflex which sits between the Nema 17 stepper motors and the frame? Would this dampen the vibrations at all? Any ninjaflex users able to test?
good call, ill wait for someone else to do it... i don't feel like tearing my steppers apart
Re: Ninjaflex dampers?
Posted: Mon May 05, 2014 11:51 pm
by McSlappy
Yeah... Even if I had them, I'd proably put it off for a while - I don't feel like pulling my machine apart just yet
