Page 1 of 1
Epic Fail!!
Posted: Sat May 03, 2014 7:43 pm
by DavidF
the e3d blew the nozzle out....damn, this is going to take some clean up time....
Re: Epic Fail!!
Posted: Sat May 03, 2014 9:11 pm
by Tinyhead
That's a pretty good one. How did it blow out the nozzle?
Re: Epic Fail!!
Posted: Sat May 03, 2014 9:27 pm
by DavidF
I have no idea, threads look ok, so somehow it unscrewed its self....and it takes quite a few turns to do that....
Re: Epic Fail!!
Posted: Sun May 04, 2014 1:57 am
by Max
I had a bowden tube fitting do that, and spooled out filment out onto the floor. Not a problem to clean up, but I was a bit surprised in the morning when I came down to check it out.
-Max