Page 1 of 1
Rostock Max V1 finally printing
Posted: Sun May 04, 2014 2:10 pm
by wavetech
Thought I would take some pix for first post.
Special thanks to Gene for the instructions.
Here it is printing 5th ABS test cube. 1st 4 tweaking to get it to stick.
Re: Rostock Max V1 finally printing
Posted: Sun May 04, 2014 3:29 pm
by Eaglezsoar
Good job in getting it working.
Re: Rostock Max V1 finally printing
Posted: Sun May 04, 2014 6:57 pm
by wavetech
This is too much fun. Do I really have to go to work tomorrow
Big turd on top of pyramid, extrude temp to hot ??
Re: Rostock Max V1 finally printing
Posted: Sun May 04, 2014 7:00 pm
by Eaglezsoar
wavetech wrote:This is too much fun. Do I really have to go to work tomorrow
Big turd on top of pyramid, extrude temp to hot ??
Most likely to hot for such a small area, is it PLA? Do you have your layer fan on?
Re: Rostock Max V1 finally printing
Posted: Sun May 04, 2014 7:46 pm
by wavetech
ABS no fan, fan not working at moment have to setup/troubleshoot.
Re: Rostock Max V1 finally printing
Posted: Sun May 04, 2014 8:38 pm
by Tinyhead
That electronics compartment is one of the cleanest I've seen so far.
When you get to things like the top of the pyramid, it gets kind of soft because it doesn't give the area time to cool. What you've got there is pretty typical. Nice first prints though!
Re: Rostock Max V1 finally printing
Posted: Mon May 05, 2014 11:11 pm
by Print_This
wavetech wrote:This is too much fun. Do I really have to go to work tomorrow
Big turd on top of pyramid, extrude temp to hot ??
lol that is hilarious, i never thought i could stand and stair for 1 or even 2 hours just watching layers by layers, mmm do i have to go to work as well lol awesome