Welcome to the SeeMeCNC Community

tested out the newest release of slic3r 0.7.2b so I can test out if we can finally print with support material... and we can! (kind of)... the support material is a cross hatch like infill, it works, but is not super easy to clean up... but it does work... which is a definate improvement... only thing that would make it better is if the support material was just a little bit farther away from walls... here's a cleaned up test from thingiverse for support material test

[img]http://www.guanu.net/seemecnc/support_test.jpg[/img]

Guanu

I also recorded the print on my ustream channel if you are just that bored to watch it...

Awesome!! ,, cant wait to try it out. Been hoping they would get some support material that 'works' put in..