Page 1 of 1
Repetier-Host/Slicer settings
Posted: Wed May 14, 2014 1:40 pm
by Mogarbobac
If someone has there rostock max v2 all set up and working great, id like to copy your slicer settings because im having a hell of a time dialing mine in.
Re: Repetier-Host/Slicer settings
Posted: Wed May 14, 2014 1:47 pm
by Tinyhead
What are the problems you're having? Using the settings provided in the manual, I was able to get very good starting prints. What are you printing with?
Re: Repetier-Host/Slicer settings
Posted: Wed May 14, 2014 2:11 pm
by Mogarbobac
red ABS, yeah since then ive changed my settings idk what the original were. I think i need to reset the advanced settings because i set them all to zero