Welcome to the SeeMeCNC Community

[img]http://i1166.photobucket.com/albums/q61 ... AG0678.jpg[/img]
Printer ready to go with ABS glue on the bed.
[img]http://i1166.photobucket.com/albums/q61 ... AG0682.jpg[/img]
Everything piled into the box. The plasmacam cd was insulating the velleman from shorting on the PSU. I have everything mounted nicely now.
[img]http://i1166.photobucket.com/albums/q61 ... AG0681.jpg[/img]
The other side of the box where the printer cable connects. The tote made a perfect fit for the board.
[img]http://i1166.photobucket.com/albums/q61 ... AG0683.jpg[/img]
a breather hole for exhausting the air. The box never gets warm, even after 3 hour prints. I like that it's a clean container for the mess of parts.

Nice. Where is the PS?

I was having a heck of a time posting pics last night. I have more to show. The whole electronics setup was in the box. I'll try to get more up tonight. I like it. I am mounting the velleman knob through the top of the box as well as a rocker switch for power. One cable in and 2 out to the printer. Nice and clean.