Page 1 of 1
rostock white assembled
Posted: Thu May 29, 2014 3:36 pm
by stonewater
I have a white rostock assembled and complete up to the pid tune of the bed and nozzle. so its workin..... just no time to tweak it and make it run, maybe I will buy an orion next time. will sell for 950 plus shipping with a spool of blue abs from those canadian guys... botfeeder? anyway I just dont have the time to learn the software or to tweak it.... it was a lot of fun to build!! arduino... not so much for me
Gene's manual was amazing!!
Tom C
Re: rostock white assembled
Posted: Thu May 29, 2014 3:40 pm
by geolupulus
Where are you located?
Re: rostock white assembled
Posted: Thu May 29, 2014 5:29 pm
by geneb
You don't have to mess with any Arduino stuff to get it up and running beyond the initial firmware load. Everything can be "tweaked" (for the most part) from the EEPROM table.
g.
Re: rostock white assembled
Posted: Thu May 29, 2014 11:30 pm
by stonewater
20 minutes south of portland oregon
Re: rostock white assembled
Posted: Fri May 30, 2014 6:24 pm
by jesse
I offer $700 + shipping.
Re: rostock white assembled
Posted: Mon Jun 02, 2014 1:06 am
by Print_This
jesse wrote:I offer $700 + shipping.
ill do $701 BOB
Re: rostock white assembled
Posted: Wed Jun 04, 2014 12:17 am
by Flavored Coffee
This should have been posted in Epic Fails.
Re: rostock white assembled
Posted: Sun Jun 08, 2014 6:46 pm
by stonewater
not an epic FAIL an epic run out of time!!
Re: rostock white assembled
Posted: Mon Jun 09, 2014 11:59 pm
by precisionpete
Your finished, keep it and get her finalized
You will regret selling it, t r u s t meeeeeeeeeeeeeee!
Re: rostock white assembled
Posted: Sun Feb 15, 2015 10:29 pm
by stonewater
well she is finally up and running!! printed a few things, now its time for some fine tuning!!
Tom C