Welcome to the SeeMeCNC Community

Wanted to dial in my printer a lil more precise today, so I decided to test out the nickel and bridge test files from thingiverse... took 3 rounds of the nickel to dial it in, and bridge one was already dead on first print... no cleanup..

I'd say I have it close enough where it should be fine..
Guanu

I would agree. Both look great. I used about the same color to print those out a few weeks back.

Wow, that looks good!
Can you provide thingiverse link to the two item you printed?

nickel calibration: http://www.thingiverse.com/thing:11261 this will dial in your x and y to be right
bridge test: http://www.thingiverse.com/thing:17424 helps you dial in different bridge spans

Guanu

Cool thanks Guanu!