Page 1 of 1
Eagle print
Posted: Fri Jun 13, 2014 12:41 am
by rippedmittens
Here's an eagle print i did the other day to compare quality between my printers.
The gold eagle was printed a while back on creator bot.The new white one on the rostock max2 both with with a layer height of .2
Im including the model which i slpit and modified in mesh mixer to ad some post supports.
it will show up as non manifold but still prints well.
Re: Eagle print
Posted: Fri Jun 13, 2014 5:24 am
by McSlappy
Very nice. I can't really tell from the pics, did it look on par with the older one or not?
Re: Eagle print
Posted: Fri Jun 13, 2014 7:20 am
by rippedmittens
The new white one turn out a touch cleaner.
Re: Eagle print
Posted: Fri Jun 13, 2014 7:20 am
by mhackney
Eaglezsoar HAS to print one of these for himself!
Re: Eagle print
Posted: Tue Jun 17, 2014 10:44 pm
by brent
mhackney wrote:Eaglezsoar HAS to print one of these for himself!
3D scan of Eaglezoar's head on this eagle would be a good print.
Re: Eagle print
Posted: Fri Jun 20, 2014 12:07 pm
by Eaglezsoar
brent wrote:mhackney wrote:Eaglezsoar HAS to print one of these for himself!
3D scan of Eaglezoar's head on this eagle would be a good print.
My head on that great looking eagle would make him look old, worn out, wrinkled, and beakless.
But you can betcha that I am going to grab the file and print some out.
Thanks for the original file and for the humorous comments.
