This is what a motor mount looks like for a 2550 kossel
Posted: Wed Jun 18, 2014 8:14 pm
The design is complete, but I may have to make a few changes after my misumi 2550 samples arrive.
100mm high, 0.25mm layers, 3 perimeters, 25% infill, 10mm brim
Very low curling on the ends, and a hint of a single split on one side. Overall a very successful large print.
My working theory is that by using the larger extrusions, the kossel design should scale to rostock max proportions.
[img]http://i.imgur.com/Ad7hilF.jpg[/img]
100mm high, 0.25mm layers, 3 perimeters, 25% infill, 10mm brim
Very low curling on the ends, and a hint of a single split on one side. Overall a very successful large print.
My working theory is that by using the larger extrusions, the kossel design should scale to rostock max proportions.
[img]http://i.imgur.com/Ad7hilF.jpg[/img]