Welcome to the SeeMeCNC Community

Cura_14.07 released today July 3rd!

In this revision:

Fixed a rare bug that caused the CuraEngine to crash on some models.
Added support for multiple Doodle3D boxes on the same network
Made it possible to switch between ‘'all at once’‘ and ’‘one at a time printing’'
Improved USB communication stability
Improved USB auto-detection for none-Ultimaker printers
Set retraction enabled by default and in the quickprint profiles
Fixed a bug that caused loading of really small objects to fail
Made camera keyboard controls accessible in the GCode view, use shift+up/down for layer changes now.

Mannnnn.... I literally installed 14.06 last night at 10pm. Why couldn't they have released this at 9:50pm last night?

Thanks for the heads up.
I will have to go grab the update now.

I updated my Repetier_Host last night and was SURPRISED that it offered to include Cura, so I accepted that.
Not sure that it is 14.07, but if it isn't I'll try to upgrade if/when I get it functional.

Do any of you Cura enthusiasts have settings files to share ?