Welcome to the SeeMeCNC Community

These are a few things I have made. I have used geomagic for the cad and Simplify 3d for the slicer. Printed on an Orion and using a PEI build platform (love that PEI!!) . I am building max v2 this week.

Those all look REALLY good, did you print that CLEAN sign standing up like in the picture? I don't see any support material blobs.

Generic Default wrote:Those all look REALLY good, did you print that CLEAN sign standing up like in the picture? I don't see any support material blobs.

Looks like two pieces.

Good job.

Those prints look awesome.

What is the birdhouse printed out of?

And would you mind sharing the STL. Also what bird is it designed for?

Generic Default wrote:Those all look REALLY good, did you print that CLEAN sign standing up like in the picture? I don't see any support material blobs.

Yes, it is 2 pieces. Used the text feature in M/C.

teoman wrote:What is the birdhouse printed out of?

And would you mind sharing the STL. Also what bird is it designed for?

It is just pla. I'll post the stl tomorrow, not near the computer right now. It is not designed for any type of bird, my wife wanted one made up. Made a teepee one too.

Generic Default wrote:Those all look REALLY good, did you print that CLEAN sign standing up like in the picture? I don't see any support material blobs.

That's because it's....clean!

Thank you, thank you, I'll be here all night folks!

Also, for the record, "3D'n" is now going to become a regular part of my vocabulary while referring to 3D printing.

This is going to become a thing now.

emile1138 wrote:Also, for the record, "3D'n" is now going to become a regular part of my vocabulary while referring to 3D printing.

This is going to become a thing now.

Not sure if that was a dig but I want ALL the credit.lol

lol, I'm pretty sure it wasn't a dig. I like the term, I'll help spread it!

More to the point, awesome prints! The pressure washer adapter is just ingenious

Love the pressurewasher! On thingiverse?

Holy1 wrote: Not sure if that was a dig but I want ALL the credit.lol

It depends on how you want to take it. I was one of those, "That was goofy......I love it! I'm going to do that now!" moments...

JohnStack wrote:Love the pressurewasher! On thingiverse?

Thanks, it was something I made up. Not on thingiverse.

teoman wrote:What is the birdhouse printed out of?

And would you mind sharing the STL. Also what bird is it designed for?

teoman, Here is the STL for the bird house. sorry for the delay

No probelm. Thank you for that.

Matter control says it is a 45 hour print... Whoow.

Also what support did you use on it?

teoman wrote:No probelm. Thank you for that.

Matter control says it is a 45 hour print... Whoow.

Also what support did you use on it?

I used SD3. With it you can place supports where ever you want. I just put few dead centre. Used PLA and it took 16 hours.