Layer Fan Shroud Education

Show off your latest creations, whether 3D printed or not
Post Reply
Peterh226
Plasticator
Posts: 16
Joined: Tue Aug 05, 2014 4:17 pm

Layer Fan Shroud Education

Post by Peterh226 »

Tried printing the fan shroud. This one is a bit tougher. Problems with adhesion mainly. I tried Cura, but the speed was way to high and I don't think I have the right settings. Went back to slic3r and added a brim and then with the hairspray it worked OK. ABS is quite a bit trickier than PLA, so I have a lot to learn.
Layer Fan Shroud Testing
Layer Fan Shroud Testing
Layer Fan Shroud.jpg (45.54 KiB) Viewed 2058 times
Top
Post Reply

Return to “What are YOU making?”