Welcome to the SeeMeCNC Community

Posted: **Thu Aug 28, 2014 6:22 pm**

Hello.
I started a big print and I am not sure if the hot end is not too close to the glass. Please look at the picture attached and advise.
Thanks.

Posted: **Thu Aug 28, 2014 6:26 pm**

Do you have a nice flat part bottom with little or no seams or grooves in it, no issues with prints coming loose, no issues with warping or layer separation?

If it isn't broke, don't fix it.

Posted: **Thu Aug 28, 2014 6:33 pm**

Ok, are you having a particular problem?? First layers look pretty good to me.

Welcome to the SeeMeCNC Community

Do you think that the hot end is too close? picture inside

Do you think that the hot end is too close? picture inside

Re: Do you think that the hot end is too close? picture insi

Re: Do you think that the hot end is too close? picture insi