Page 1 of 1
Maleficent Horns - (First Section) on my Rostock
Posted: Wed Sep 10, 2014 2:58 pm
by HesDeadJim
Making a set of "Maleficent" horns for a Halloween costume. The entire project is comprised of six sections, this is a video of the first section. Using black ABS. (sorry for the wiggle...I should have centered more on the piece...I'm learning...)
[youtube]
http://www.youtube.com/watch?v=H5UtwuQ4k6k[/youtube]
Here's the external link for those who can't view it on the forum:
https://www.youtube.com/watch?v=H5UtwuQ4k6k
Re: Maleficent Horns - (First Section) on my Rostock
Posted: Wed Sep 10, 2014 5:37 pm
by teoman
whoow you have nice bed adhesion.
Will you be willing to share the stl's and settings?
Re: Maleficent Horns - (First Section) on my Rostock
Posted: Thu Sep 11, 2014 12:19 pm
by HesDeadJim
The files are all on Thingiverse. Here's the link:
http://www.thingiverse.com/thing:453002
The skullcap pieces (the largest pieces) are best printed upside down, so flip them 90 degrees from how they load so the "horn" is flat on the bed. This saves a TON of filament (not so much support generated) and a LOT of time (like, a whole day...)
Enjoy!
Re: Maleficent Horns - (First Section) on my Rostock
Posted: Thu Sep 11, 2014 3:54 pm
by HesDeadJim
I'll grab my settings when I get home and post them. Anything in particular you might need?
Re: Maleficent Horns - (First Section) on my Rostock
Posted: Thu Sep 11, 2014 5:30 pm
by teoman
Speeds temps support settings...
Those are pretty big prints and with my luck they will picass at 99%.
Re: Maleficent Horns - (First Section) on my Rostock
Posted: Thu Sep 11, 2014 7:00 pm
by HesDeadJim
I took screenshots of the settings I used for the Maleficent prints and will post them below. I use ABS juice for the bed adhesion.
Re: Maleficent Horns - (First Section) on my Rostock
Posted: Fri Sep 12, 2014 1:24 am
by Hydrolove
Thanks for the setting. Seeing the part and the setting that go with it is a good idea. Maybe we could come up with a standard way to post that.
Kris