Page 1 of 1
Tool's of the trade for the ratrod of 3d printer's
Posted: Mon Sep 15, 2014 9:21 pm
by timothysvec
Just little project I did up today. The hemostats are to pull the glob off the hot end. And the rolling paper's to set the hight offset. The screw driver is for bed adjustment. It's like a repurposed herb organizer for rep raps!
Re: Tool's of the trade for the ratrod of 3d printer's
Posted: Mon Sep 15, 2014 9:43 pm
by timothysvec
After a little clean up... Sweet!
Re: Tool's of the trade for the ratrod of 3d printer's
Posted: Mon Sep 15, 2014 9:55 pm
by timothysvec
A close up.
Re: Tool's of the trade for the ratrod of 3d printer's
Posted: Thu Sep 18, 2014 4:37 am
by teoman
Did you use double sided sticky tape?
Sorry just noticed it is press fit.