Welcome to the SeeMeCNC Community

Hello,

I tried my first ninja fkex print and the results are in the pic attached.

hot end temp 215
bed 40
layer fan off
speed 15
retraction off

what can i do to get better results?

thanks

Have you done the extruder mod that adds the little length of bowden tube above the extruder?

Nop, can you please give some more details or maybe a link?

thanks

duvdev wrote:Nop, can you please give some more details or maybe a link?

thanks

Here is the link: http://forum.seemecnc.com/viewtopic.php ... 832#p43832