Can you guess what im building?
Posted: Sun Sep 28, 2014 10:24 am
Welcome to the SeeMeCNC Community
Have a look around and join today!
https://download.seemecnc.com/
Can you guess what im building?
Page 1 of 1
Re: Can you guess what im building?
Posted: Sun Sep 28, 2014 11:23 am
Hmmm, could this be another piece to your ROV? Perhaps a motor mount for the arm?
Re: Can you guess what im building?
Posted: Sun Sep 28, 2014 11:31 am
A droplit kind of thingie?
With the motor going in the centre and the guides attaching to the sides?
With the motor going in the centre and the guides attaching to the sides?
Re: Can you guess what im building?
Posted: Sun Sep 28, 2014 12:43 pm
Some kind of a motor mount (the wires in the picture).... Perhaps a motorized knife? (the other element in the picture)
Re: Can you guess what im building?
Posted: Sun Sep 28, 2014 2:00 pm
Re: Can you guess what im building?
Posted: Sun Sep 28, 2014 3:14 pm
Good job for nailing it, Teoman!
Re: Can you guess what im building?
Posted: Sun Sep 28, 2014 4:46 pm
Is it for the Z axis of a droplit or similar?
Re: Can you guess what im building?
Posted: Sun Sep 28, 2014 4:47 pm
Will there be some kind of ballbearing on the other side? Or will you put another motor?
Re: Can you guess what im building?
Posted: Sun Sep 28, 2014 5:13 pm
Still playing with it. Need to test the resolution and see how its going to work out.
But yes its for a Dlp type printer.
But yes its for a Dlp type printer.
Re: Can you guess what im building?
Posted: Sun Sep 28, 2014 8:11 pm
Please do share. I have intention of building one myself.
Re: Can you guess what im building?
Posted: Sun Sep 28, 2014 8:31 pm
I'm more than happy to share, and will post files when a bit further along. I just threw this together in a couple hours to see if it "felt" like it would work. This is the second iteration, and it might just work....teoman wrote:Please do share. I have intention of building one myself.
