Page 1 of 1
SlyForce1_Rostock_Max_V2_
Posted: Sat Nov 01, 2014 12:49 pm
by Slyforce1
Hello everyone,
My first print has completed and i am very happy with this machine.
I printed the fan shroud and layer fan holder to get started.
Re: SlyForce1_Rostock_Max_V2_
Posted: Mon Nov 03, 2014 5:52 pm
by Slyforce1
Here is a Fan Keychain trinket i downloaded from "UMAKE".
Re: SlyForce1_Rostock_Max_V2_
Posted: Mon Nov 03, 2014 7:19 pm
by McSlappy
Hey, nice looking prints!
Does the fan spin when you blow on it?
Re: SlyForce1_Rostock_Max_V2_
Posted: Fri Nov 07, 2014 3:28 pm
by Slyforce1
i had to do a little sanding on it, but spins nicely. i tied it to my big fan to wear it in.
SANTAS_HELPER_
Posted: Fri Nov 07, 2014 3:46 pm
by Slyforce1
Here is a ornament i downloaded from Thingiverse.
had a few issues with it but came out pretty nice,
was a lot bigger than i was expecting though.