Page 1 of 1
New spool holder
Posted: Sun Nov 30, 2014 4:53 pm
by Kitecraft
I made me a new spool holder with a roller that lets the spool spin with no resistance.
And it has a spider web!
[youtube]
http://www.youtube.com/watch?v=qLd0qxH3U5o[/youtube]
Re: New spool holder
Posted: Sun Nov 30, 2014 5:11 pm
by JFettig
Looks nice! Do you have models to share? preferably in something SLDPRT, IGS, STP or similar so its easier to tweak
Re: New spool holder
Posted: Sun Nov 30, 2014 5:56 pm
by Captain Starfish
That's killer! Surprised the friction is still so low for just a tube running on rod, very neat. And dat web
Re: New spool holder
Posted: Sun Nov 30, 2014 9:34 pm
by rpress
That looks fun! What CAD software did you use?
Re: New spool holder
Posted: Mon Dec 01, 2014 8:37 am
by Kitecraft
Thanks all.
I use 123D Design from Autodesk. I tried to attache the 123D file, but the forum software won't let me.
Cheers
Re: New spool holder
Posted: Mon Dec 01, 2014 12:18 pm
by Mac The Knife
You can trick the board by renaming the file type,,,, or I think a zipped file will work.
Re: New spool holder
Posted: Thu Dec 04, 2014 11:54 pm
by Kitecraft
All right, let's try this again.
Re: New spool holder
Posted: Fri Dec 05, 2014 7:15 am
by Eaglezsoar
It opens fine as an ascii which netfabb converts with no problems.
Thank you for the files!
Re: New spool holder
Posted: Fri Dec 05, 2014 7:40 pm
by emile1138
Nice design! While I was at it I also watched a few of your other YouTube videos.
Keep up the good work!!
Re: New spool holder
Posted: Fri Dec 05, 2014 8:00 pm
by shapeshifter
Hey thats pretty cool, nice idea!