Welcome to the SeeMeCNC Community

I want to change the horizontal setting in eeprom. My orion delta is not connected to USB. How can I change the setting manually?
Instructions? I am trying the level the table.
doing three point test and also the center curvature gcode test.

I think you have to be connected to a host. Not positive, but I was just looking for it today on my rmax and I ended up just using rep-host.

I guess I'm behind the times, though, because everyone seems to use matter control these days.

There isn't a way to modify the radius without a host software, thats not one of the editable variables in the UI.