Burn in test
Posted: Wed Dec 10, 2014 6:28 pm
Not really, just loaded the third spool of filament this week on my old printer and it's currently preheating. I only have one more spool of PLA and the new ones have been sitting in a UPS trailer for the past couple of days due to a work slow-down of some sort.
I guess if I run out I have more time for my other clients?
Looked at the list of orders, assuming the spools show up I'm still going to be printing while Santa is trying to fit in our chimney and while the bubbly is flowing.
My RMax is due in Friday, hope we have time to assemble it!
I guess if I run out I have more time for my other clients?
Looked at the list of orders, assuming the spools show up I'm still going to be printing while Santa is trying to fit in our chimney and while the bubbly is flowing.
My RMax is due in Friday, hope we have time to assemble it!