Ipad Mini Mount for DJI vision plus
Posted: Mon Dec 15, 2014 6:36 pm
- Good(better side of the first layer skirt
- Skirt between xand y
- On the DJI Phantom tx
- Side view of piece
Filament used is Microcenter red printed at 230 with 90c bed temp
Just got the Rostock max v2 10 days ago,I've been tweaking and troubleshooting and I'm finally getting the hang of the fine tuning aspect.I'm posting a few pics of an adapter(not my design) I'm pretty happy with the outcome considering how the 3 loop skirt was laying down when the print first started. I've posted a few images of the adhesion problem that is happening between xand y. The piece warped a bit but it's still fully functional for my needs. The piece lifted up on two corners during the last two minutes of the print, it appears that the upper layers were pulling up the bottom or maybe I didn't use enough Aqua Net?..
Filament used is Microcenter red printed at 230 with 90c bed temp