Weekend project that bled over into Monday...
Posted: Mon Jun 25, 2012 7:05 pm
After a few frustrating days trying to get my new machine to extrude, I finally got it! And so, while I wait on an order for some filament to get here, I decided to build a cabinet for the electronics. This is what I came up with.
The grill in the front hides a fan that blows air right over the board and out the back. I left room out the back where the power supply sits so I could let the warm air out and also as a place to run all the wires in. The power supply fan draws air in the right side. I don't have a heated bed yet, but I put a power switch in so I'm ready when I do!
So, what do you think?
Douglas
The grill in the front hides a fan that blows air right over the board and out the back. I left room out the back where the power supply sits so I could let the warm air out and also as a place to run all the wires in. The power supply fan draws air in the right side. I don't have a heated bed yet, but I put a power switch in so I'm ready when I do!
So, what do you think?
Douglas