M119 shows X V Z

[KAS]

I've installed everything following the assembly guide for a new Rostock Max V2.

When I issue the M119 command in the Terminal in MatterControl I see the following.

Is this something I messed up or is the labeling wrong for the Y axis?

[img]http://i482.photobucket.com/albums/rr189/Onuxis/XVZ.png[/img]

[JFettig]

it just doesn't show the hook of the small y since it goes below the line into the next one.

[KAS]

Awesome, thank you. Thought I was going nuts.