Welcome to the SeeMeCNC Community

So i have a couple of these laying around, and i love this design. http://forum.seemecnc.com/viewtopic.php?p=45675#p45675
Thats the STL i used.. it works great.. except that in going to the edge of the build plate, it gets in the way and snaps off at the base.
Curious if anyone else has a nice setup for a 40mm peek fan?
I already have 3 layer fans in all three spots (guanus new one, LOVE IT). so i cant use that mounting hole.
Or do you really need a peek fan that badly? I must admit, since that one broke, i havent replaced it, and its been a while haha.
bad on me i know.
thoughts?

There's this one http://repables.com/r/99/

ooh that one i did not find... thats nice... ill give that one a try..
thanks

unfortunately it printed great, but when mounted the black bar (where the arms attach to the white pegs) isnt able to rise above it where it needs to go.. so i either have to cut it or something..

When my peek fan was going out, I just ordered a couple more, with ball bearings, to replace it. Going with the original size fan saved the hassles of trying to make something else fit.

With the super reliability of these fans, I just ordered a spare and we haven't even assembled the RMax yet.

Also figure we'll skip the Diablotek supply altogether and use one of the industrial regulated supplies. I have a 12V, 30A one for another project I'll "borrow".

what i dont get is that this model for the print is from repables, and done by our seemecnc but it doesnt work with the stock v2?... you would think it would be plug n play.

Here's an updated model that I'm currently using with no problems

http://forum.seemecnc.com/viewtopic.php ... 675#p45675