Orion Settings for Cura

D-Ring · Post by **D-Ring** » Mon Jan 26, 2015 11:01 am

Anyone have configuration for setting up the Orion printer in Cura. Looking for the machine profile. I can do the print profiles that I have been using with MatterControl and transfer them over, just looking to play with the cura software to compare

Jimustanguitar · Post by **Jimustanguitar** » Mon Jan 26, 2015 11:26 am

http://slicershare.com/files/2406-2/

Here's what I use on my Rostock with a .4mm nozzle. There are a few changes between that and an Orion, but not many besides the actual build area.

Renha · Post by **Renha** » Mon Oct 26, 2015 10:50 am

Jimustanguitar · Post by **Jimustanguitar** » Mon Oct 26, 2015 12:37 pm

Renha wrote:404

Their website is acting strange. Not that it was awesome to begin with

Does the direct link to the file work?
http://slicershare.com/wp-content/uploa ... s/2406.ini

If not, I posted the same .ini file on the MakerHive forum: http://makerhive.proboards.com/thread/8 ... -materials

Welcome to the SeeMeCNC Community

Orion Settings for Cura

Orion Settings for Cura

Re: Orion Settings for Cura

Re: Orion Settings for Cura

Re: Orion Settings for Cura