Movement detector
Posted: Mon Jan 26, 2015 4:14 pm
Has anyone come up with some kind of sensor that can detect if the print has come loose off the base, and therefore stops the print before you waste a pile of filament?
Obviously you could only set it up/switch it on after its begun printing - perhaps 5mm off the bed. I am thinking of a laser tape measure type system pointing at the base of your print (electronics is my hobby)
Just an idea
Obviously you could only set it up/switch it on after its begun printing - perhaps 5mm off the bed. I am thinking of a laser tape measure type system pointing at the base of your print (electronics is my hobby)
Just an idea