Hello from NYC
Posted: Tue Jan 27, 2015 7:06 pm
Hi All!
I built a RM V2 back in December, but just got around to posting here. A big reason I decided to go with the Rostock was the brains and community that comprise this forum. The machine is all stock, and I'll most likely keep it that way until I have a good reason to mod. If I were to do so, it would probably begin with a higher amp power supply, and a nylon capable hotend (E3D V6 + volcano?). Whereas the machine currently resides in my bathroom, it will soon be banished to my shop whether or not I install motor dampers.
Anyway, you'll see me around asking some n00b questions (but not without researching them first!)
All the best,
REV
I built a RM V2 back in December, but just got around to posting here. A big reason I decided to go with the Rostock was the brains and community that comprise this forum. The machine is all stock, and I'll most likely keep it that way until I have a good reason to mod. If I were to do so, it would probably begin with a higher amp power supply, and a nylon capable hotend (E3D V6 + volcano?). Whereas the machine currently resides in my bathroom, it will soon be banished to my shop whether or not I install motor dampers.
Anyway, you'll see me around asking some n00b questions (but not without researching them first!)
All the best,
REV