Welcome to the SeeMeCNC Community

Posted: **Fri Jul 20, 2012 9:45 pm**

Well not really but petty close. Still need to wire up the controller and pretty much every thing else. I have two LED thermostats from ebay. One for the heated bed, the other I hope to be able to use the thermocoupler and the led readout to measure the temp on the hot end. The first picture is of the plexiglas box we made for the electronics and the two blue cooling fans.

: Ellen's box and blue cooling fans

: Front view.

: View from the top

: Position LED and Velleman Thermostat

Posted: **Fri Jul 20, 2012 9:49 pm**

We put the box together so we can take the printer off and use the controller system for a CNC if we wanted to.

Posted: **Thu Jul 26, 2012 9:43 am**

Nice enclosure , Is there a way for the air to circulate though?

Posted: **Thu Jul 26, 2012 9:13 pm**

We have a large fan on the top pulling air out to the bottom of the table and one in the front to push air into the enclosure. So far it seems to be keeping everything cool.

Posted: **Fri Jul 27, 2012 7:21 pm**

Ok Just wondering

Welcome to the SeeMeCNC Community

I R DONE!!!!!1

I R DONE!!!!!1

Re: I R DONE!!!!!1

Re: I R DONE!!!!!1

Re: I R DONE!!!!!1

Re: I R DONE!!!!!1