Page 1 of 1
Can anyone recommend a true red PLA or ABS
Posted: Tue Feb 03, 2015 4:46 pm
by mechg
I bought some Hatchbox red PLA, which prints beautifully, but it comes out a bit on the orangey side. If you have experience with a good quality, true-RED pla or abs, please let me know.
Re: Can anyone recommend a true red PLA or ABS
Posted: Tue Feb 03, 2015 6:12 pm
by Mac The Knife
SeeMeCNC's red abs is red, and prints alright. Gizmo dorks is kinda translucent,,
Re: Can anyone recommend a true red PLA or ABS
Posted: Tue Feb 03, 2015 6:31 pm
by McSlappy
If you're in Australia, Plastrude RED ABS and PLA is pretty red.
Re: Can anyone recommend a true red PLA or ABS
Posted: Tue Feb 03, 2015 11:38 pm
by BenTheRighteous
I just finished printing some roses using Push Plastic PLA. The color was perfect for that application.
Re: Can anyone recommend a true red PLA or ABS
Posted: Wed Feb 04, 2015 12:38 am
by DavidF
colorfabb, traffic red.....
Re: Can anyone recommend a true red PLA or ABS
Posted: Wed Feb 04, 2015 12:55 am
by Nylocke
IC3D. Green is green, blue is blue, etc..