Page 1 of 1
Ho Slot Car Body
Posted: Fri Feb 06, 2015 11:58 am
by beilmandesign
I think I am asking too much from my Max 2. I drew the body in solidworks so it is a viable stl file. ABS, 2mm layer height.
Re: Ho Slot Car Body
Posted: Fri Feb 06, 2015 12:30 pm
by Khalid Khattak
2mm layer height...wow
Re: Ho Slot Car Body
Posted: Fri Feb 06, 2015 12:43 pm
by DavidF
Nah, your not asking too much from it. You just need to learn to print a little better. Try going with a .1mm layer height and slow your print speed to 20 mm/sec.
Re: Ho Slot Car Body
Posted: Fri Feb 06, 2015 12:52 pm
by Khalid Khattak
I normally print ABS at 0.2mm layer height at 50mm/sec with very good results...