Page 1 of 1
squaring extrusions to bed
Posted: Tue Feb 17, 2015 12:18 am
by Cheeto
Is there some trick to this? All my extrusions are slightly angled inwards, if I get one square the other two are worse. is there any other spots to work with possibly besides the tslot? I'll post some quick pix.
Thanks,
Doug
Re: squaring extrusions to bed
Posted: Tue Feb 17, 2015 12:30 am
by Cheeto
Re: squaring extrusions to bed
Posted: Tue Feb 17, 2015 12:42 am
by Cheeto
How flat should the heated bed be?
Re: squaring extrusions to bed
Posted: Tue Feb 17, 2015 1:25 am
by bubbasnow
I haven't read the manual in a while, are we still squaring the towers to the base before heat bed installation? I don't see the top of the printer but make all your tower adjustments before you put the top on else it will cause more headaches.